AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Impact of acoustic wave propagation characteristics on aerodynamic damping of rotor blades in a transonic axial compressor

Yongbo YUa,b, Yanrong WANGa,b, Le HANc( )
School of Energy and Power Engineering, Beihang University, Beijing 100191, China
Collaborative Innovation Center for Advanced Aero-Engine, Beijing 100191, China
Research Institute of Aero-Engine, Beihang University, Beijing 100191, China

Peer review under responsibility of Editorial Committee of CJA

Show Author Information

Abstract

The aeroelastic stability associated with the acoustic wave propagation characteristics of transonic rotor blades was numerically investigated in this study. The influence of the vibration frequency on the aerodynamic damping of the first bending mode was primarily considered at different speeds, including both work and stall points. We found that the state of acoustic wave propagation associated with aeroelastic instability is closely related to rotational speed. At low speeds near stall points, the risk of aeroelastic instability is confined to the upstream cut-off state. However, at high speeds near stall points, aeroelastic instability may occur in both the downstream cut-off state and the acoustic wave propagation state of the upstream cut-off frequency, further expanding the range of the acoustic wave propagation state in which aeroelastic instability can arise. The research findings show that for suction surfaces, aerodynamic work is affected not only by acoustic wave propagation characteristics, but also by shock waves, radial flow, and reflux in the flow field. However, for pressure surfaces, the acoustic wave propagation characteristics play a significant role. When aeroelastic instability occurs, negative damping predominantly arises from the pressure surface. To investigate why lower-order modes are more prone to aeroelastic instability, specific simulations were conducted for the first bending and twisting modes under different operating conditions in the downstream cut-on state. When the vibration frequency significantly exceeds the downstream cut-off frequency, the blade phase is minimally influenced by acoustic wave propagation characteristics, and the rotor is aeroelastically stable in these phases. Simultaneously, there is an approximately linear increase in the unsteady pressure amplitude with increasing vibration frequency, and the aerodynamic work is predominantly influenced by the unsteady pressure amplitude.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 168-187

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
YU Y, WANG Y, HAN L. Impact of acoustic wave propagation characteristics on aerodynamic damping of rotor blades in a transonic axial compressor. Chinese Journal of Aeronautics, 2024, 37(11): 168-187. https://doi.org/10.1016/j.cja.2024.08.009

591

Views

13

Crossref

6

Web of Science

10

Scopus

1

CSCD

Received: 06 December 2023
Revised: 07 January 2024
Accepted: 30 April 2024
Published: 12 August 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).