AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Loaded tooth contact analysis and meshing stiffness calculation for cracked spiral bevel gears

Zhen LIUa, Fucai LIa( ), Wenjie BAOb, Xiaolei XUa, Freeda A. AMIRc
State Key Laboratory of Mechanical System and Vibration, Shanghai Jiao Tong University, Shanghai 200240, China
School of Mechatronic Engineering, China University of Mining and Technology, Xuzhou 221116, China
Jiangsu JITRI Composite Equipment Research Institute Co., Ltd., Wuxi 214000, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

Tooth cracks may occur in spiral bevel gear transmission system of the aerospace equipment. In this study, an accurate and efficient loaded tooth contact analysis (LTCA) model is developed to predict the contact behavior and time-varying meshing stiffness (TVMS) of spiral bevel gear pair with cracked tooth. The tooth is sliced, and the contact points on slices are computed using roll angle surfaces. Considering the geometric complexity of crack surface, a set of procedures is formulated to generate spatial crack and determine crack parameters for contact points. According to the positional relationship between contact point and crack path, each sliced tooth is modeled as a non-uniform cantilever beam with varying reduced effective load-bearing tooth thickness. Then the compliance model of the cracked tooth is established to perform contact analysis, along with TVMS calculations utilizing three different models. By employing spiral bevel gear pairs with distinct types of cracks as examples, the accuracy and efficiency of the developed approach are validated via comparative analyses with finite element analysis (FEA) outcomes. Furthermore, the investigation on effects of cracks shows that tooth cracks can induce alterations in meshing performance of both entire gear pair and individual tooth pairs, including not only cracked tooth pair but also adjacent non-cracked tooth pairs. Hence, the proposed model can serve as a useful tool for analyzing the variations in contact behavior and meshing stiffness of spiral bevel gears due to different cracks.

Electronic Supplementary Material

Download File(s)
cja-38-3-103085_ESM.pdf (112.3 KB)

References

【1】
【1】
 
 
Chinese Journal of Aeronautics

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
LIU Z, LI F, BAO W, et al. Loaded tooth contact analysis and meshing stiffness calculation for cracked spiral bevel gears. Chinese Journal of Aeronautics, 2025, 38(3). https://doi.org/10.1016/j.cja.2024.05.041

1831

Views

9

Crossref

16

Web of Science

17

Scopus

1

CSCD

Received: 31 January 2024
Revised: 19 March 2024
Accepted: 02 May 2024
Published: 03 June 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).