AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Strengthened and toughened SiHfBCN-based high-temperature resistant adhesive with SiC NWs

Xingang LUAN( ), Xiyue ZHU, Xichao DONG, Min LI, Laifei CHENG
Science and Technology on Thermostructural Composite Materials Laboratory, Northwestern Polytechnical University, Xi’an 710072, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

To further improve the performance of binders, a SiHfBCN-based high-temperature resistant adhesive was successfully synthesized by Polymer-Derived Ceramics (PDC) route using TiB2, Polysiloxane (PSO) and short SiC nanowires as fillers. The effect of short SiC nanowires on the adhesive strength at room temperature and high temperature, as well as the reinforcing mechanism was studied. Compared with the adhesive without SiC nanowires, after curing (at 170 ℃) and pyrolysis (at 1000 ℃) in air, the appropriate adding of SiC nanowires upgrades the room temperature and high temperature (at 1000 ℃ in air) adhesive strength to (12.50 ± 0.67) MPa (up by about 32%) and (13.11 ± 0.79) MPa (up by about 106%), respectively. Attractively, under the synergistic impact of the nanowire bridging, nanowire breaking, nanowire drawing and crack deflection, the optimized adhesive exhibits multi-stage fracture, causing the increscent fracture displacement.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 539-549

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
LUAN X, ZHU X, DONG X, et al. Strengthened and toughened SiHfBCN-based high-temperature resistant adhesive with SiC NWs. Chinese Journal of Aeronautics, 2024, 37(7): 539-549. https://doi.org/10.1016/j.cja.2024.05.013

921

Views

5

Crossref

4

Web of Science

5

Scopus

1

CSCD

Received: 01 August 2023
Revised: 04 September 2023
Accepted: 10 October 2023
Published: 16 May 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).