AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Investigation of control effects of end-wall self-adaptive jet on three-dimensional corner separation of a highly loaded compressor cascade

Hejian WANGa,b, Bo LIUa,b, Xiaochen MAOa,b( ), Botao ZHANGc, Zonghao YANGa,b
School of Power and Energy, Northwestern Polytechnical University, Xi’an 710129, China
The National Key Laboratory of Science and Technology on Aerodynamic Design and Research, Xi’an 710129, China
Taihang Laboratory, Chengdu 610000, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

To overcome the limitations posed by three-dimensional corner separation, this paper proposes a novel flow control technology known as passive End-Wall (EW) self-adaptive jet. Two single EW slotted schemes (EWS1 and EWS2), alongside a combined (COM) scheme featuring double EW slots, were investigated. The results reveal that the EW slot, driven by pressure differentials between the pressure and suction sides, can generate an adaptive jet with escalating velocity as the operational load increases. This high-speed jet effectively re-excites the local low-energy fluid, thereby mitigating the corner separation. Notably, the EWS1 slot, positioned near the blade leading edge, exhibits relatively low jet velocities at negative incidence angles, causing jet separation and exacerbating the corner separation. Besides, the EWS2 slot is close to the blade trailing edge, resulting in massive low-energy fluid accumulating and separating before the slot outlet at positive incidence angles. In contrast, the COM scheme emerges as the most effective solution for comprehensive corner separation control. It can significantly reduce the total pressure loss and improve the static pressure coefficient for the ORI blade at 0°-4° incidence angles, while causing minimal negative impact on the aerodynamic performance at negative incidence angles. Therefore, the corner stall is delayed, and the available incidence angle range is broadened from −10°–−2° to −10°–4°.This holds substantial promise for advancing the aerodynamic performance, operational stability, and load capacity of future highly loaded compressors.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 109-126

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
WANG H, LIU B, MAO X, et al. Investigation of control effects of end-wall self-adaptive jet on three-dimensional corner separation of a highly loaded compressor cascade. Chinese Journal of Aeronautics, 2024, 37(6): 109-126. https://doi.org/10.1016/j.cja.2024.04.009

921

Views

7

Crossref

7

Web of Science

9

Scopus

0

CSCD

Received: 23 October 2023
Revised: 02 January 2024
Accepted: 25 February 2024
Published: 12 April 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).