AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Effect of linear friction welding process on microstructure evolution, mechanical properties and corrosion behavior of GH4169 superalloy

Yu SUa, Xiawei YANGa( ), Tingxi MENGa, Dong WUa, Rui XUa, Haiyu XUa, Wenya LIa, Shuo YINb
State Key Laboratory of Solidification Processing, School of Materials Science and Engineering, Northwestern Polytechnical University, Xi’an 710072, China
Department of Mechanical, Manufacturing & Biomedical Engineering, Parsons Building, Trinity College Dublin, The University of Dublin, Dublin 2, Ireland

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

Linear Friction Welding (LFW) technology was used to realize the welding of GH4169 superalloy, and the effect of welding parameters on the microstructure, mechanical properties and corrosion behavior of the joint was analyzed. The results show that there is a positive correlation between the weld hardness and the tensile strength. With the gradual increase of heat input and welding pressure, the joint quality is gradually improved, but the heat affected zone is not significantly increased. The smaller the grain size of the weld, the higher the strength and plasticity of the joint. With the increase of the joint shortening amount, the corrosion resistance of the weld first gradually increases. However, when the shortening reaches a certain level, the corrosion resistance of the joint becomes little changed. With the increase of solution temperature, the corrosion current density increases and the polarization impedance decreases. The higher the corrosion temperature, the worse the corrosion resistance of the joint. There is no significant correlation between the joint strength and the corrosion resistance. The corrosion resistance of the joint can be enhanced without changing the joint mechanical properties by reducing the welding frequency and amplitude or increasing the welding pressure.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 504-520

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
SU Y, YANG X, MENG T, et al. Effect of linear friction welding process on microstructure evolution, mechanical properties and corrosion behavior of GH4169 superalloy. Chinese Journal of Aeronautics, 2024, 37(6): 504-520. https://doi.org/10.1016/j.cja.2024.03.039

994

Views

69

Crossref

65

Web of Science

72

Scopus

5

CSCD

Received: 30 November 2023
Revised: 24 December 2023
Accepted: 21 February 2024
Published: 29 March 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).