AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Temperature field characteristics of CF/PEEK thermoplastic composites formed by automated fiber placement using hot gas torch with slit structure nozzle

Ziang JINa,b, Shouzheng SUNa, Sunil Chandrakant JOSHIb, Zhenyu HANa( ), Hongya FUa
State Key Laboratory of Robotics and System, Harbin Institute of Technology, Harbin 150001, China
School of Mechanical and Aerospace Engineering, Nanyang Technological University, Singapore 639798, Singapore

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

In-situ consolidation forming of high-performance thermoplastic composites by Automated Fiber Placement (AFP) is of significant interest in aerospace. During the laying process, the heating temperature has a great influence on the quality of the formed components. A three-dimensional heat transfer finite element model of Carbon Fiber (CF)/Polyether Ether Ketone (PEEK) heated by Slit Structure Nozzle Hot Gas Torch (SSNHGT) assisted AFP is proposed. The influence of gas flow rate, heat transfer distance, and laying speed on heating temperature is analysed. The results show that the overall temperature increases and then decreases as the gas flow rate increases. With the increase in heat transfer distance and laying speed, the overall temperature decreases. Meanwhile, the gas flow rate has the greatest influence on the temperature of CF/PEEK being heated, followed by the laying speed and finally the heat transfer distance. Furthermore, the model can also be extended to other fiber-reinforced polymer composites formed by hot gas torch assisted AFP, which can guide the optimization of process parameters for subsequent heating temperature control.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 392-409

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
JIN Z, SUN S, JOSHI SC, et al. Temperature field characteristics of CF/PEEK thermoplastic composites formed by automated fiber placement using hot gas torch with slit structure nozzle. Chinese Journal of Aeronautics, 2024, 37(6): 392-409. https://doi.org/10.1016/j.cja.2024.03.032

1098

Views

11

Crossref

11

Web of Science

12

Scopus

0

CSCD

Received: 30 May 2023
Revised: 29 June 2023
Accepted: 13 August 2023
Published: 02 April 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).