AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Low-frequency chatter suppression in robotic milling using Magnetorheological Joint Damper (MRJD)

Shihao XINa, Xiaowei TANGa( ), Jiawei WUa, Fangyu PENGa,b, Rong YANa, Kai SUNa
School of Mechanical Science and Engineering, Huazhong University of Science and Technology, Wuhan 430074, China
State Key Laboratory of Intelligent Manufacturing Equipment and Technology, Huazhong University of Science and Technology, Wuhan 430074, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

Low-frequency structural vibrations caused by poor rigidity are one of the main obstacles limiting the machining efficiency of robotic milling. Existing vibration suppression strategies primarily focus on passive vibration absorption at the robotic end and feedback control at the joint motor. Although these strategies have a certain vibration suppression effect, the limitations of robotic flexibility and the extremely limited applicable speed range remain to be overcome. In this study, a Magnetorheological Joint Damper (MRJD) is developed. The joint-mounted feature ensures machining flexibility of the robot, and the millisecond response time of the Magnetorheological Fluid (MRF) ensures a large effective spindle speed range. More importantly, the evolution law of the damping performance of MRJD was revealed based on a low-frequency chatter mechanism, which guarantees the application of MRJD in robotic milling machining. To analyze the influence of the robotic joint angle on the suppression effect of the MRJD, the joint braking coefficient and end braking coefficient were proposed. Parallel coordinate plots were used to visualize the joint range with the optimal vibration suppression effect. Finally, a combination of different postures and cutting parameters was used to verify the vibration suppression effect and feasibility of the joint angle optimization. The experimental results show that the MRJD, which directly improves the joint vibration resistance, can effectively suppress the low-frequency vibration of robotic milling under a variety of cutting conditions.

Electronic Supplementary Material

Download File(s)
cja-38-3-102974_ESM.pdf (792.9 KB)

References

【1】
【1】
 
 
Chinese Journal of Aeronautics

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
XIN S, TANG X, WU J, et al. Low-frequency chatter suppression in robotic milling using Magnetorheological Joint Damper (MRJD). Chinese Journal of Aeronautics, 2025, 38(3). https://doi.org/10.1016/j.cja.2024.03.011

1348

Views

16

Crossref

13

Web of Science

17

Scopus

1

CSCD

Received: 16 January 2024
Revised: 14 February 2024
Accepted: 21 February 2024
Published: 13 March 2024
© 2024 Chinese Society of Aeronautics and Astronautics

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).