AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Review Article | Open Access

Machining dynamics and chatters in micro-milling: A critical review on the state-of-the-art and future perspectives

Qingshun BAIa( ), Peng WANGa, Kai CHENGb, Liang ZHAOa, Yabo ZHANGa
School of Mechanical and Electrical Engineering, Harbin Institute of Technology, Harbin 150001, China
Department of Mechanical and Aerospace Engineering, Brunel University London, Uxbridge UB8 3PH, UK

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

Micro-milling technology is widely applied in micro manufacturing, particularly for the fabrication of miniature and micro components. However, the chatters and machining dynamics related issues in micro-milling are often the main challenges restricting its machining quality and productivity. Many research works have rendered that the machining dynamics and chatters in micro-milling are more complex compared with the conventional macro-milling process, likely because of the size effect and rigidity of the micro-milling system including the tooling, workpiece, process variables, materials involved, and the high-speed milling machines, and further their collective dynamic effects. Therefore, in this paper, the state of the art focusing on micro-milling chatters and dynamics related issues over the past years are comprehensively and critically reviewed to provide some insights for potential researchers and practitioners. Firstly, typical applications and the problems caused by the machining dynamics and chatters in micro-milling have been put forward in this paper. Then, the research on the underlying micro-cutting mechanics and dynamics, stability analysis, chatters detection, and chatter suppression are summarized critically. Furthermore, the underlying scientific and technological challenges are discussed particularly against typical precision engineering applications. Finally, the possible future directions and trends in research and development of micro-milling have been discussed.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 59-80

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
BAI Q, WANG P, CHENG K, et al. Machining dynamics and chatters in micro-milling: A critical review on the state-of-the-art and future perspectives. Chinese Journal of Aeronautics, 2024, 37(7): 59-80. https://doi.org/10.1016/j.cja.2024.02.022

1421

Views

31

Crossref

26

Web of Science

29

Scopus

0

CSCD

Received: 20 July 2023
Revised: 09 August 2023
Accepted: 06 October 2023
Published: 05 March 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).