AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

A deformation criterion of pressurized non-circular cross-section cabin and its effects on cruise performance of BWB civil aircraft

Siyi GUOa, Zhenli CHENa( ), Xuanyu YAOb
School of Aeronautics, Northwestern Polytechnical University, Xi’an 710072, China
Aero Engine Academy of China, Beijing 101304, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

Blended-Wing-Body (BWB) aircraft is promoted as one of the most possible layouts to achieve more sustainable civil aviation. Due to the non-circular cross-section of the center-body, a bulge deformation forms over the upper surface of the body under the coupled loads of the internal pressurization of the cabin and the aerodynamic bending moments of the wing, which reduces the lift-to-drag ratio of BWB aircraft. Under a limited deformation, the relationship between the aerodynamic performance and the structural weight needs to be studied. In this work, the effects of stiffness constraints on the center-body deformation, structural weight of the airframe and aerodynamic performance were investigated by using an analytical model of the Pultruded Rod Stitched Efficient Unitized Structure (PRSEUS) for the airframe and the computational fluid dynamics method, respectively. The results show that as the stiffness constraint increases, the spacings between the rod stringers and the frame stiffeners decrease, and the structural weight increases inversely. A 5.2% reduction of the lift-to-drag ratio is encountered at cruise for a medium deformation design of 42.8 mm/m. A higher aerodynamic penalty is suffered when the stiffness constraint is further released. The final deformation criterion is different when the weight vector of the aerodynamic performance and structural weight is different.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 78-88

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
GUO S, CHEN Z, YAO X. A deformation criterion of pressurized non-circular cross-section cabin and its effects on cruise performance of BWB civil aircraft. Chinese Journal of Aeronautics, 2024, 37(6): 78-88. https://doi.org/10.1016/j.cja.2024.02.016

863

Views

1

Crossref

1

Web of Science

1

Scopus

0

CSCD

Received: 05 July 2023
Revised: 11 September 2023
Accepted: 29 October 2023
Published: 28 February 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).