AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Body-force modeling considering induced upstream effects for a transonic compressor with total temperature distortion

Jiahui QIUa,b,c, Chen YANGa,b,c, Wenqiang ZHANGd, Min ZHANGa,b,c, Juan DUa,b,c( )
Digital Twin Research Center, Institute of Engineering Thermophysics, Chinese Academy of Sciences, Beijing 100190, China
School of Engineering and Science, University of Chinese Academy of Sciences, Beijing 100190, China
National Key Laboratory of Science and Technology on Advanced Light-duty Gas-turbine, Chinese Academy of Sciences, Beijing 100190, China
School of Mechatronical Engineering, Beijing Institute of Technology, Beijing 100081, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

To numerically study the impact of total temperature distortion on a transonic compressor with reduced computational costs, a Body-Force Model (BFM) is developed. Firstly, the interactions between the distorted flow and the compressor are analyzed using full-annulus Unsteady Reynolds-Averaged Navier-Stokes (URANS) results and the orbit method. It is found that the induced swirl distortion and the mass flux nonuniformity are intensified in the compressor upstream flow field. A correction factor is thus added to the BFM to account for the effect of the induced swirl, which is crucial for the accurate representation of distortion transfer in the intake. Then, steady simulations with large-amplitude 180° circumferential total temperature distortion are performed using the developed BFM. It is shown that the distorted compressor map simulated with the BFM matches well with URANS results. The circumferential phase shift of total temperature and the generation of the additional total pressure distortion across the rotor are in line with the time-averaged URANS flow field. The compressor upstream effects on the distorted inflow can also be exactly captured. All above-mentioned results demonstrate the BFM developed in this paper can effectively capture the distorted flow features inside the compressor, and significantly reduce the computational costs by five orders of magnitude compared with URANS.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 7-19

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
QIU J, YANG C, ZHANG W, et al. Body-force modeling considering induced upstream effects for a transonic compressor with total temperature distortion. Chinese Journal of Aeronautics, 2024, 37(6): 7-19. https://doi.org/10.1016/j.cja.2024.02.006

922

Views

10

Crossref

8

Web of Science

10

Scopus

2

CSCD

Received: 06 June 2023
Revised: 26 June 2023
Accepted: 11 September 2023
Published: 14 February 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).