AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Early chatter identification based on optimized VMD with multi-band information fusion and compression method in robotic milling process

Sichen CHENa, Zhiqiang LIANGa,b( ), Yuchao DUa, Zirui GAOa, Haoran ZHENGa, Zhibing LIUa, Tianyang QIUa, Xibin WANGa
School of Mechanical Engineering, Beijing Institute of Technology, Beijing 100081, China
Beijing Institute of Technology Chongqing Innovation Center, Chongqing 401120, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

Undesirable self-excited chatter has always been a typical issue restricting the improvement of robotic milling quality and efficiency. Sensitive chatter identification based on processing signals can prompt operators to adjust the machining process and prevent chatter damage. Compared with the traditional machine tool, the uncertain multiple chatter frequency bands and the band-moving of the chatter frequency in robotic milling process make it more challenging to extract chatter information. This paper proposes a novel method of chatter identification using optimized variational mode decomposition (OVMD) with multi-band information fusion and compression technology (MT). During the robotic milling process, the number of decomposed modes k and the penalty coefficient α are optimized based on the dominant component of frequency scope partition and fitness of the mode center frequency. Moreover, the mayfly optimization algorithm (MA) is employed to obtain the global optimal parameter selection. In order to conquer information collection about the uncertain multiple chatter frequency bands and the band-moving of the chatter frequency in robotic milling process, MT is presented to reduce computation and extract signal characteristics. Finally, the cross entropy of the image (CEI) is proposed as the final chatter indicator to identify the chatter occurrence. The robotic milling experiments are carried out to verify the proposed method, and the results show that it can distinguish the robotic milling condition by extracting the uncertain multiple chatter frequency bands and overcome the band-moving of the chatter frequency in robotic milling process.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 464-484

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
CHEN S, LIANG Z, DU Y, et al. Early chatter identification based on optimized VMD with multi-band information fusion and compression method in robotic milling process. Chinese Journal of Aeronautics, 2024, 37(6): 464-484. https://doi.org/10.1016/j.cja.2023.10.009

1061

Views

18

Crossref

19

Web of Science

18

Scopus

1

CSCD

Received: 24 June 2023
Revised: 29 June 2023
Accepted: 25 August 2023
Published: 16 October 2023
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).