AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Geometrically compatible integrated design method for conformal rotor and nacelle of distributed propulsion tilt-wing UAV

Cheng HEa( ), Gang CHENb, Xue SUNb, Shuangfei LIb, Yang LIa
Unmanned Air Vehicle Research Institute, Nanjing University of Aeronautics and Astronautics, Nanjing 210016, China
Aerospace System Engineering Shanghai, Shanghai 201108, China
Show Author Information

Abstract

The inner rotors of distributed propulsion tilt-wing Unmanned Aerial Vehicles (UAVs) are often folded in the cruising state and deployed in vertical take-off and landing to cope with the huge difference in thrust requirements. However, the blades of the conventional rotor have poor conformality with the nacelle profile, which will greatly increase the drag of the UAV after folding. This paper proposes an integrated method for the design of rotor and nacelle considering geometric compatibility to reduce the drag of the folded rotor and nacelle, so as to further improve the aerodynamic efficiency in cruise while ensuring the rotor efficiency in the vertical flight mode. A geometric mapping model based on nacelle design parameters and rotor design parameters is established, and a parametric model and aerodynamic optimization model of the outer arc airfoil family are developed. In addition, a rotor performance analysis model and a neural network response surface model for nacelle drag prediction that meet the requirements of confidence level are established. Based on the oblique inflow blade element momentum theory method, numerical simulation method, and genetic algorithm, an integrated optimization framework of the design of the conformal rotor and nacelle is built. Then, a geometrically compatible integrated optimization for the rotor and nacelle is carried out with the objective of maximizing energy efficiency in the full mission profile. Finally, a conformal rotor and nacelle design solution is obtained, which satisfies geometric compatibility and thrust constraints while providing high thrust efficiency and low cruising drag. A comparison of the results of the integrated design and the conventional rotor optimization design shows that the drag of the conventional rotor is 3.45 times that of the conformal integrated design in the cruising state, which proves the effectiveness and necessity of the proposed method.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 229-245

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
HE C, CHEN G, SUN X, et al. Geometrically compatible integrated design method for conformal rotor and nacelle of distributed propulsion tilt-wing UAV. Chinese Journal of Aeronautics, 2023, 36(10): 229-245. https://doi.org/10.1016/j.cja.2023.06.005

968

Views

5

Crossref

5

Web of Science

6

Scopus

1

CSCD

Received: 14 September 2022
Revised: 06 November 2022
Accepted: 21 December 2022
Published: 12 June 2023
© 2023 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).