AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Influence of mandrel-cores filling on size effect of cross-section distortion of bimetallic thin-walled composite bending tube

Yingxia ZHUa( ), Miaomiao WANa, Wei CHENa, Yun WANGa, Wenbin TUb, Fan XUa
School of Mechanical Engineering, Jiangsu University, Zhenjiang 212013, China
School of Mechanical Engineering, Guilin University of Aerospace Technology, Guilin 541004, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

Two new size factors of cross-section hollow coefficient and bending degree are introduced to reveal the size effect of bending forming of bimetallic composite tube. Hollow coefficient and bending degree can limit the commonly used bent tube to the size description range of (0, 2.00). The evolution laws of the cross-section distortion forms in the hollow coefficient-bending degree interval are revealed as well as the action of the mandrel-cores on the size effect. Results show the mandrel-cores filling can expand the forming limit of the bent tube, but also bring two other forming defects of wrinkle and rupture. The identification factor (hollow coefficient multiply bending degree) provides a method for querying the cross-section distortion forms of all composite bending tubes. In the identification factor interval (0, 1.00), the distribution area of bending forming defects of the composite tube is continuous. The thin-walled composite bending tube collapses when identification factor in (0, 0.39), wrinkles when identification factor in [0.39, 0.50), and ruptures when identification factor in [0.50, 1.00). The mathematical model of size effect is derived, by which the average cross-section distortion rate is found to distribute like a radial leaf in the hollow coefficient-bending degree qualified forming space. The best forming zone is hollow coefficient 0.46–0.68, and bending degree 0.25–0.47.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 421-435

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
ZHU Y, WAN M, CHEN W, et al. Influence of mandrel-cores filling on size effect of cross-section distortion of bimetallic thin-walled composite bending tube. Chinese Journal of Aeronautics, 2023, 36(3): 421-435. https://doi.org/10.1016/j.cja.2022.11.008

961

Views

12

Crossref

10

Web of Science

12

Scopus

1

CSCD

Received: 05 May 2022
Revised: 23 June 2022
Accepted: 22 July 2022
Published: 17 November 2022
© 2022 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).