AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Numerical simulation method of surge experiments on gas turbine engines

Xinqian ZHENGa,b, Hanxuan ZENGa( ), Baotong WANGb, Mengyang WENb, Heli YANGb, Zhenzhong SUNb
School of Vehicle and Mobility, Tsinghua University, Beijing 100084, China
Institute for Aero Engine, Tsinghua University, Beijing 100084, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

In order to obtain the surge margin of an aero-engine during its operation, an engine surge experiment is required. A multi-dimensional simulation method for an aero-engine is established in this paper. The simulation of a surge experiment using high-pressure air-injection is then carried out on a turbo-shaft engine to obtain the surge boundary using this method. More specifically, firstly, a body-force model is employed to calculate the compressor performance owing to its capability of capturing the main three-dimensional features of compressor surge and avoiding excessive simulation time required by the traditional fully-three-dimensional Reynolds Averaged Navier-Stokes (RANS) method. Then, a one-dimensional model combining a lumped-parameter plenum model is used for the combustor to account for the propagation of pressure waves and the heat-release process, and a zero-dimensional throttle model is used to mimic the choking effect at the turbine nozzle. Finally, the air-injection system is modeled by imposing an injection boundary condition, which can be used conveniently in changing injection parameters. Based on the established method, the influences of different test parameters, such as the air-injection location, the pressure, the orifice size, the number of injection orifices, and the injection time duration on the surge characteristics and boundary are further studied, which offer effective guidance to optimize an actual experimental design.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 107-120

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
ZHENG X, ZENG H, WANG B, et al. Numerical simulation method of surge experiments on gas turbine engines. Chinese Journal of Aeronautics, 2023, 36(3): 107-120. https://doi.org/10.1016/j.cja.2022.08.007

1021

Views

23

Crossref

22

Web of Science

27

Scopus

4

CSCD

Received: 14 February 2022
Revised: 07 March 2022
Accepted: 27 April 2022
Published: 12 August 2022
© 2022 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).