AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Characteristics of surface and subsurface of formed thread parts by axial-infeed thread rolling process

Shuowen ZHANGa, Dawei ZHANGa( ), Shengdun ZHAOa, Fei JIANGa, Myoung-Gyu LEEb
Xi'an Key Laboratory of Intelligent Equipment and Control, School of Mechanical Engineering, Xi’an Jiaotong University, Xi’an 710049, China
Department of Materials Science and Engineering, Seoul National University, 08826 Seoul, Republic of Korea

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

The thread rolling process has been widely applied to manufacture high-performance thread parts. In this process, the evolutions of surface and subsurface are frequently introduced, which affect the working performance of manufactured parts. In this study, an axial-infeed thread rolling process (ATRP) is employed, and the macro-meso surface characteristics under different lubrications and operating conditions are investigated. Moreover, the distributions of microstructure and hardness on the subsurface of formed tooth are analyzed in detail, along with the study of stress state and yield strength change. It is found that the MoS2 grease is more effective in reducing the surface roughness and defects than the lubrication oil and water-base graphite during the ATRP process. Increasing rolling speed improves the quality of surface morphology and can reduce the surface roughness. On the subsurface of bottom and flank, intensive shear stress occurs in a narrow region, resulting in the elongation and refinement of the grains and increasing the low angle grain boundary fraction. Based on the grain size and plastic strain, the yield strength is predicted. The maximum yield strength and hardness on the bottom of formed tooth are improved by 41.2% and 39.4%, respectively.

Electronic Supplementary Material

Download File(s)
cja-36-3-471_ESM.pdf (851.7 KB)

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 471-481

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
ZHANG S, ZHANG D, ZHAO S, et al. Characteristics of surface and subsurface of formed thread parts by axial-infeed thread rolling process. Chinese Journal of Aeronautics, 2023, 36(3): 471-481. https://doi.org/10.1016/j.cja.2022.07.019

847

Views

19

Crossref

18

Web of Science

22

Scopus

1

CSCD

Received: 23 February 2022
Revised: 11 April 2022
Accepted: 09 May 2022
Published: 22 July 2022
© 2022 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).