Effect of cooling strategies on performance and mechanism of helical milling of CFRP/Ti-6Al-4 V stacks

Hole-making for Carbon Fiber Reinforced Plastics (CFRP)/Ti-6Al-4 V stacks is crucial for the assembling strength of aircraft structure parts. This work carried out experimental work for helical milling (HM) of the stacks with sustainable cooling/lubrication (dry, MQL and cryogenic) conditions. Cutting forces and temperatures at the CFRP layer, Ti-6Al-4 V layer and the interface of stacks were obtained by a developed measuring system. The temperatures in CFRP machining at cryogenic condition varied from −167 ℃ to −94 ℃, which were much lower than those at dry and MQL conditions. The maximum temperature near the interface of stacks for the ninth hole was higher than 240 ℃ due to heat conduction from Ti-6Al-4 V layer. The hole quality, hole diameter and tool wear mechanism at different cooling/lubrication conditions were presented and discussed. MQL condition generated mainly extrusion fracture for the fibers, due to the reduced friction effect compared with dry condition. MQL was helpful to reduce the feed mark at the hole surface of Ti-6Al-4 V alloy. The flank wear of cutting edge at MQL condition was better than those at dry and cryogenic conditions. Cryogenic cooling contributed to better CFRP surface with smaller delamination and hole entrance damage due to the increased resin strength and fiber brittleness. The damage near the entrance of CFRP were analyzed by the contact state of cutting edges and fibers. Additionally, hole diameters near the exit of CFPR layer were larger than other test positions. This work provided feasible processes for improving hole quality and tool life in hole-making of CFRP/Ti-6Al-4 V stacks.