AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (1.9 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research paper | Open Access

Improving maize growth and development simulation by integrating temperature compensatory effect under plastic film mulching into the AquaCrop model

Chao ZhangaJiying KongaMin TangaWen LincDianyuan Dinga( )Hao Fengb( )
College of Hydraulic Science and Engineering, Yangzhou University, Yangzhou 225009, Jiangsu, China
Institute of Water Saving Agriculture in Arid Areas of China, Northwest A&F University, Yangling 712100, Shaanxi, China
Collage of Agriculture, Shanxi Agricultural University, Jinzhong 30801, Shanxi, China
Show Author Information

Abstract

Temperature compensatory effect, which quantifies the increase in cumulative air temperature from soil temperature increase caused by mulching, provides an effective method for incorporating soil temperature into crop models. In this study, compensated temperature was integrated into the AquaCrop model to investigate the capability of the compensatory effect to improve assessment of the promotion of maize growth and development by plastic film mulching (PM). A three-year experiment was conducted from 2014 to 2016 with two maize varieties (spring and summer) and two mulching conditions (PM and non-mulching (NM)), and the AquaCrop model was employed to reproduce crop growth and yield responses to changes in NM, PM, and compensated PM. A marked difference in soil temperature between NM and PM was observed before 50 days after sowing (DAS) during three growing seasons. During sowing–emergence and emergence–tasseling, the increase in air temperature was proportional to the compensatory coefficient, with spring maize showing a higher compensatory temperature than summer maize. Simulation results for canopy cover (CC) were generally in good agreement with the measurements, whereas predictions of aboveground biomass and grain yield under PM indicated large underestimates from 60 DAS to the end of maturity. Simulations of spring maize biomass and yield showed general increase based on temperature compensation, accompanied by improvement in modeling accuracy, with RMSEs decreasing from 2.5 to 1.6 t ha−1 and from 4.1 t to 3.4 t ha−1. Improvement in biomass and yield simulation was less pronounced for summer than for spring maize, implying that crops grown during low-temperature periods would benefit more from the compensatory effect. This study demonstrated the effectiveness of the temperature compensatory effect to improve the performance of the AquaCrop model in simulating maize growth under PM practices.

References

【1】
【1】
 
 
The Crop Journal
Pages 1559-1568

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Zhang C, Kong J, Tang M, et al. Improving maize growth and development simulation by integrating temperature compensatory effect under plastic film mulching into the AquaCrop model. The Crop Journal, 2023, 11(5): 1559-1568. https://doi.org/10.1016/j.cj.2023.05.008

688

Views

6

Downloads

11

Crossref

11

Web of Science

13

Scopus

1

CSCD

Received: 16 December 2022
Revised: 13 April 2023
Accepted: 15 June 2023
Published: 06 July 2023
© 2023 Crop Science Society of China and Institute of Crop Science, CAAS.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).