References(51)
[1]
R Lencina, C Caletti, K Brunelli, R Micone. Assessing wear performance of two high-carbon Hadfield steels through field tests in the mining industry. Proced Mater Sci 9: 358-366 (2015)
[2]
M Lindqvist, C M Evertsson. Liner wear in jaw crushers. Miner Eng 16(1): 1-12 (2003)
[3]
M Lindroos, M Apostol, V Heino, K Valtonen, A Laukkanen, K Holmberg, V T Kuokkala. The deformation, strain hardening, and wear behavior of chromium-alloyed Hadfield steel in abrasive and impact conditions. Tribol Lett 57(3): 24 (2015)
[4]
R Sinha, A K Mukhopadhyay. Wear characterization and modelling of Mn-steel liners used in rock crushers. Perspect Sci 8: 374-376 (2016)
[5]
J Terva, V T Kuokkala, K Valtonen, P Siitonen. Effects of compression and sliding on the wear and energy consumption in mineral crushing. Wear 398-399: 116-126 (2018)
[6]
D Canadinc, H Sehitoglu, H J Maier, Y I Chumlyakov. Strain hardening behavior of aluminum alloyed Hadfield steel single crystals. Acta Mater 53(6): 1831-1842 (2005)
[7]
D Canadinc, H Sehitoglu, H J Maier, D Niklasch, Y I Chumlyakov. Orientation evolution in Hadfield steel single crystals under combined slip and twinning. Int J Solids Struct 44(1): 34-50 (2007)
[8]
Y Dastur, W Leslie. Mechanism of work hardening in Hadfield manganese steel. Metall Trans A 12(5): 749-759 (1981)
[9]
B Hutchinson, N Ridley. On dislocation accumulation and work hardening in Hadfield steel. Scr Mater 55(4): 299-302 (2006)
[10]
O Onal, C Ozmenci, D Canadinc. Multi-scale modeling of the impact response of a strain-rate sensitive high-manganese austenitic steel. Front Mater 1: 16 (2014)
[11]
E Bayraktar, C Levaillant, S Altintas. Strain rate and temperature effect on the deformation behavior of the original Hadfield steel. J Phys IV 3: C7 61-66 (1993)
[12]
D Canadinc, C Efstathiou, H Sehitoglu. On the negative strain rate sensitivity of Hadfield steel. Scr Mater 59: 1103-1106 (2008)
[13]
P H Adler, G B Olson, W S Owen. Strain hardening of Hadfield manganese steel. Metall Mater Trans A 17(10): 1725-1737 (1986)
[14]
H Idrissi, K Renard, L Ryelandt, D Schryvers, P J Jacques. On the mechanism of twin formation in Fe-Mn-C TWIP steels. Acta Mater 58(7): 2464-2476 (2010)
[15]
I Karaman, H Sehitoglu, K Gall, Y I Chumlyakov, H J Maier. Deformation of single crystal Hadfield steel by twinning and slip. Acta Mater 48(6): 1345-1359 (2000)
[16]
W S Owen, M Grujicic. Strain aging of austenitic Hadfield manganese steel. Acta Mater 47(1): 111-126 (1998)
[17]
B K Zuidema, D Subramanyam, W C Leslie. The effect of aluminum on the work hardening and wear resistance of Hadfield manganese steel. Metall Mater Trans A 18(9): 1629-1639 (1987)
[18]
I Karaman, H Sehitoglu, A J Beaudoin, Y I Chumlyakov, H J Maier, C N Tomé. Modeling the deformation behavior of hadfield steel single and polycrystals due to twinning and slip. Acta Mater 48(9): 2031-2047 (2000)
[19]
M Lindroos, G Cailletaud, A Laukkanen, V T Kuokkala. Crystal plasticity modeling and characterization of the deformation twinning and strain hardening in Hadfield steels. Mater Sci Eng A 720: 145-159 (2018)
[20]
M Lindroos, A Laukkanen, G Cailletaud, V T Kuokkala. On the effect of deformation twinning and microstructure to strain hardening of high manganese austenitic steel 3D microstructure aggregates at large strains. Int J Solids Struct 125: 68-76 (2017)
[21]
D Canadinc, H Sehitoglu, I Karaman, Y Chumlyakov, H Maier. The role of nitrogen on the deformation response of Hadfield steel single crystals. Metall Mater Trans A 34(9): 1821-1831 (2003)
[22]
S M Toker, D Canadinc, A Taube, G Gerstein, H J Maier. On the role of slip-twin interactions on the impact behavior of high-manganese austenitic steels. Mater Sci Eng A 593: 120-126 (2014)
[23]
B Gumus, B Bal, G Gerstein, D Canadinc, H J Maier. Twinning activity in high-manganese austenitic steels under high velocity loading. Mater Sci Technol 32(5): 463-465 (2015)
[24]
B Gumus, B Bal, G Gerstein, D Canadinc, H J Maier, F Guner, M Elmadagli. Twinning activities in high-Mn austenitic steels under high-velocity compressive loading. Mater Sci Eng 648: 104-112 (2015)
[25]
M Lindroos, A Laukkanen, G Cailletaud, V T Kuokkala. Microstructure based modeling of the strain rate history effect in wear resistant Hadfield steels. Wear 396-397: 56-66 (2018)
[26]
B Bal, B Gumus, D Canadinc. Incorporation of dynamic strain aging into a viscoplastic self-consistent model for predicting the negative strain rate sensitivity of Hadfield steel. J Eng Mater Technol, 138(3): 031012
[27]
E Biyikli, S M Toker, D Canadinc. Incorporating the grain boundary misorientation effects on slip activity into crystal plasticity. Mech Adv Mater Struct 23(8): 865-872 (2016)
[28]
M Mirzajanzadeh, D Canadinc. A microstructure-sensitive model for simulating the impact response of a high-manganese austenitic steel. J Eng Mater Technol 138(4): 041004 (2016)
[29]
K Holmberg, A Laukkanen, H Ronkainen, K Wallin, S Varjus, J Koskinen. Tribological contact analysis of a rigid ball sliding on a hard coated surface: Part I: Modelling stresses and strains. Surf Coat Technol 200(12-13): 3793-3809 (2006)
[30]
K Holmberg, A Laukkanen, E Turunen, T Laitinen. Wear resistance optimisation of composite coatings by computational microstructural modelling. Surf Coat Technol 247: 1-13 (2014)
[31]
A Laukkanen, M Lindroos, T Andersson, T Verho, T Pinomaa. Micromechanical modeling of failure behavior of metallic materials. Rakent Mek 50(3): 271-274 (2017)
[32]
P A Sabnis, S Forest, N K Arakere, V A Yastrebov. Crystal plasticity analysis of cylindrical indentation on a Ni-base single crystal superalloy. Int J Plast 51: 200-217 (2013)
[33]
Y F Gao, B C Larson, J H Lee, L Nicola, J Z Tischler, G M Pharr. Lattice rotation patterns and strain gradient effects in face-centered-cubic single crystals under spherical indentation. J Appl Mech 82: 061007 (2015)
[34]
L Nicola, A F Bower, K S Kim, A Needleman, E van der Giessen. Multi-asperity contact: A comparison between discrete dislocation and crystal plasticity predictions. Philos Mag 88(30-32): 3713-3729 (2008)
[35]
W D Musinski, D L McDowell. On the eigenstrain application of shot-peened residual stresses within a crystal plasticity framework: Application to Ni-base superalloy specimens. Int J Mech Sci 100: 195-208 (2015)
[36]
T Rousseau, C Nouguier-Lehon, P Gilles, T Hoc. Finite element multi-impact simulations using a crystal plasticity law based on dislocation dynamics. Int J Plast 101: 42-57 (2018)
[37]
J Durand, H Proudhon, G Cailletaud. Contact between rough surfaces: Crystal plasticity influence on the contact tightness estimation. Blucher Mech Eng Proc 1(1): 1-12 (2014)
[38]
A Laukkanen, K Holmberg, H Ronkainen, G Stachowiak, P Podsiadlo, M Wolski, M Gee, C Gachot, L Li. Topographical orientation effects on surface stresses influencing on wear in sliding DLC contacts, part 2: Modelling and simulations. Wear 388-389: 18-28 (2017)
[39]
M Lindroos. Experimental and numerical studies on the abrasive and impact behavior of wear resistant steels. Ph.D. Thesis. Tampere (Finland): Tampere University of Technology, 2016.
[40]
M Lindroos, K Valtonen, A Kemppainen, A Laukkanen, K Holmberg, V T Kuokkala. Wear behavior and work hardening of high strength steels in high stress abrasion. Wear 322-323: 32-40 (2015)
[41]
P Franciosi. The concepts of latent hardening and strain hardening in metallic singlecrystals. Acta Metall 33(9): 1601-1612 (1985)
[42]
S R Kalidindi. Modeling anisotropic strain hardening and deformation textures in low stacking fault energy FCC metals. Int J Plast 17: 837-860 (2001)
[43]
A A Salem, S R Kalidindi, S L Semiatin. Strain hardening due to deformation twinning in α-titanium: Constitutive relations and crystal-plasticity modeling. Acta Mater 53(12): 3495-3502 (2005)
[44]
M Lindroos, A Laukkanen, V T Kuokkala. A crystal plasticity approach for shear banding in hot rolled high-strength steels. Metall Mater Trans A 48(11): 5608-5615 (2017)
[45]
K P Mingard, H G Jones, M G Gee. Metrological challenges for reconstruction of 3-D microstructures by focused ion beam tomography methods. J Microsc 253(2): 93-108 (2014)
[46]
W Ludwig, A King, P Reischig, M Herbig, E M Lauridsen, S Schmidt, H Proudhon, S Forest, P Cloetens, S R du Roscoat, et al. New opportunities for 3d materials science of polycrystalline materials at the micrometre lengthscale by combined use of X-ray diffraction and X-ray imaging. Mater Sci Eng 524(1-2): 69-76 (2009)
[47]
C Efstathiou, H Sehitoglu. Strain hardening and heterogeneous deformation during twinning in Hadfield steel. Acta Mater 58(5): 1479-1488 (2010)
[48]
H Chen, D Zhao, Q L Wang, Y H Qiang, J W Qi. Effects of impact energy on the wear resistance and work hardening mechanism of medium manganese austenitic steel. Friction 5(4): 447-454 (2017)
[49]
S L Wong, M Madivala, U Prahl, F Roters, D Raabe. A crystal plasticity model for twinning- and transformation- induced plasticity. Acta Mater 118: 140-151 (2016)
[50]
P A Sabnis, S Forest, J Cormier. Microdamage modelling of crack initiation and propagation in FCC single crystals under complex loading conditions. Int J Eng Sci 312: 468-491 (2016)
[51]
O Aslan, N M Cordero, A Gaubert, S Forest. Micromorphic approach to single crystal plasticity and damage. Int J Eng Sci, 49(12): 1311-1325 (2011)