AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Powered by AMiner. Clicking this button will take you away from SciOpen.
Home Friction Article
PDF (16.5 MB)
Cite
EndNote(RIS) BibTeX
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article | Open Access

Effect of pulsed magnetic field pre-treatment of AISI 52100 steel on the coefficient of sliding friction and wear in pin-on-disk tests

Anatolii BABUTSKYI( ), Andreas CHRYSANTHOU, Chuanli ZHAO
School of Engineering and Technology, University of Hertfordshire, Hatfield, UK
Show Author Information

Abstract

Disc specimens manufactured from commercial bearing rollers (AISI 52100 steel, 62−63 HRC) in initial state and after pre-treatment by pulsed magnetic field (PMF) with a magnetic field strength of 1−7 MA/m were tested with sunflower oil using pin-on-disk apparatus. According to the obtained results the treatment causes a reduction in the coefficient of friction and wear. To explain the results, nano- and microhardness tests as well as optical and atomic force microscopy were used. Reasons of the effect of PMF on the friction and wear were discussed.

Keywords

bearing rollerspulsed magnetic field

References

【1】
【1】
 
 
Crossref Google Scholar
Friction
Volume 2 Issue 4,
December 2014
Pages 310-316
DOI: 10.1007/s40544-014-0048-0

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Cite this Report
Close
Close
Cite this article:
BABUTSKYI A, CHRYSANTHOU A, ZHAO C. Effect of pulsed magnetic field pre-treatment of AISI 52100 steel on the coefficient of sliding friction and wear in pin-on-disk tests. Friction, 2014, 2(4): 310-316. https://doi.org/10.1007/s40544-014-0048-0

1176

Views

84

Downloads

23

Crossref

N/A

Web of Science

21

Scopus

0

CSCD
Received: 15 September 2013
Revised: 03 March 2014
Accepted: 14 April 2014
Published: 14 July 2014
© The author(s) 2014

This article is published with open access at Springerlink.com

Open Access: This article is distributed under the terms of the Creative Commons Attribution License which permits any use, distribution, and reproduction in any medium, provided the original author(s) and source are credited.