AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Submit Manuscript
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Regular | Open Access

MSM Fiber Optic Surface Plasmon Resonance Glucose Sensor Based on SnO2 Nanofibers/Au Structure

Hongyu SONG, Haoyu WU, Yanpei XU, Shaowei MA, Meng SUN, Qi WANG( )
College of Sciences, Northeastern University, Shenyang 110819, China
Show Author Information

Abstract

Glucose is an indispensable nutrient for metabolism in living organisms and is widely used in food, industry, and medical fields. Glucose is often added as a sweetener in food and often used in industry as a reducing agent for various products. In medical treatment, glucose is added to many drugs as a nutritional additive, and it is also an indicator that diabetics need to pay attention to at all time. Therefore, the market has a great demand for low-cost, high-sensitivity, fast, and convenient glucose sensors, and the industry has always attached great importance to the work of creating new glucose sensor devices. Therefore, we proposed a SnO2 nanofibers/Au structure multimode-single-mode-multimode (MSM) fiber surface plasmon resonance (SPR) glucose sensor. SnO2 nanofibers were fixed to a single-mode fiber core that had been plated with the Au film by electrospinning. When the glucose concentration increased at 5 vol% intervals, the corresponding resonance wavelengths had different degrees of redshifts. Comparing the two structures, as the glucose concentration range increased from 0 vol% to 60 vol%, the sensitivity increased from 228.7 nm/vol% in the Au structure to 337.3 nm/vol% in the SnO2 nanofiber/Au structure. At the same time, the linear correlation between the resonant wavelength and the refractive index of the two structures was greater than 0.98. Moreover, the SnO2 nanofibers/Au structure significantly improved the practical application performance of SPR sensors.

References

【1】
【1】
 
 
Photonic Sensors
Article number: 250119

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
SONG H, WU H, XU Y, et al. MSM Fiber Optic Surface Plasmon Resonance Glucose Sensor Based on SnO2 Nanofibers/Au Structure. Photonic Sensors, 2025, 15(1): 250119. https://doi.org/10.1007/s13320-024-0733-1

1126

Views

17

Crossref

17

Web of Science

19

Scopus

0

CSCD

Received: 15 October 2023
Revised: 16 February 2024
Published: 10 July 2024
© The Author(s) 2024.

This article is distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made.