AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Submit Manuscript
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article

Amplitude-mode spectroscopy of chemically injected and photogenerated charge carriers in semiconducting single-walled carbon nanotubes

Shai R. Vardeny1, Alan Phillips2,3, Kira A. Thurman2, Z. Valy Vardeny4, Jeffrey L. Blackburn2( )
Division of Electrical, Electronic, and Infocommunications Engineering, Osaka University, 2-1 Yamada-oka, Suita, Osaka 565-0871, Japan
Materials, Chemistry, and Computation Science Directorate, National Renewable Energy Laboratory, Golden, CO 80401, USA
Department of Physics, Colorado School of Mines, Golden, CO 80401, USA
Department of Physics & Astronomy, University of Utah, Salt Lake City, UT 84112, USA
Show Author Information

Abstract

In one-dimensional semiconductors such as conjugated polymers and semiconducting single-walled carbon nanotubes (s-SWCNTs), injected charge carriers (electrons or holes) can have profound impacts on both electronic conductivity and optical spectra, even at low carrier densities. Understanding charge-related spectral features is a key fundamental challenge with important technological implications. Here, we employ a systematic suite of experimental and theoretical tools to understand the mid-infrared charge signatures of heavily p-type doped polymer-wrapped s-SWCNTs. Across a broad range of nanotube diameters, we find that hole charge carriers induce strong Fano anti-resonances in mid-infrared transmission spectra that correspond to defect-related (D-band) and in-plane tangential (G-band) Raman-active vibrational modes, along with anti-resonances arising from infrared (IR)-active polymer and SWCNT modes. We employ 13C isotope-labeled s-SWCNTs and a removable wrapping polymer to clarify the relative intensities, energies, and sources of all observed anti-resonances. Simulations performed with the “amplitude mode model” are used to quantitatively reproduce Raman spectra and also help to explain the outsized intensity of the D-band anti-resonance, relative to the G-band, observed for both moderately and degenerately doped s-SWCNTs. The results provide a framework for future studies of ground- and excited-state charge carriers in s-SWCNTs and a variety of low-dimensional materials.

Graphical Abstract

The amplitude mode model helps to simulate Raman and FTIR spectra of doped semiconducting singlewalled carbon nanotubes and explain the origins of Fano anti-resonances in FTIR spectra.

Electronic Supplementary Material

Download File(s)
12274_2022_5080_MOESM1_ESM.pdf (1.5 MB)

References

【1】
【1】
 
 
Nano Research
Pages 5619-5625

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Vardeny SR, Phillips A, Thurman KA, et al. Amplitude-mode spectroscopy of chemically injected and photogenerated charge carriers in semiconducting single-walled carbon nanotubes. Nano Research, 2023, 16(4): 5619-5625. https://doi.org/10.1007/s12274-022-5080-1
Topics:

11997

Views

3

Crossref

4

Web of Science

4

Scopus

0

CSCD

Received: 10 July 2022
Revised: 13 September 2022
Accepted: 20 September 2022
Published: 18 November 2022
© Tsinghua University Press 2022