AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Submit Manuscript
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article

Ultra-robust triboelectric nanogenerator for harvesting rotary mechanical energy

Xinyu Du1,§, Nianwu Li1,§, Yuebo Liu2, Jiaona Wang2, Zuqing Yuan1,4, Yingying Yin1,4, Ran Cao1,4, Shuyu Zhao2, Bin Wang2, Zhong Lin Wang1,3,4, Congju Li1( )
Beijing Institute of Nanoenergy and NanosystemsChinese Academy of SciencesNational Center for Nanoscience and Technology (NCNST)Beijing100083China
School of Materials Science & EngineeringBeijing Institute of Fashion TechnologyBeijing100029China
School of Material Science and EngineeringGeorgia Institute of TechnologyAtlanta, Georgia30332-0245USA
University of Chinese Academy of SciencesBeijing100049China

§ Xinyu Du and Nianwu Li contributed equally to this work.

Show Author Information

Abstract

Triboelectric nanogenerators (TENGs) for harvesting rotary mechanical energy are mostly based on in-plane sliding or free-standing mode. However, the relative displacement between two contacting triboelectric layers causes abrasion, which lowers the output power and reduces service life. Therefore, it is important to develop a method to minimize abrasion when harvesting rotary mechanical energy. Here, we report a scale-like structured TENG (SL-TENG), in which two triboelectric layers work under a contact-separation mode to avoid in-plane relative sliding in order to minimize abrasion. As a result, the SL-TENG exhibits outstanding robustness. For example, the output voltage of the SL-TENG does not exhibit any measurable decay although this output has been continuously generated through more than a million cycles. Moreover, at a very low rotation rate of 120 rpm, the SL-TENG can generate a maximum short-circuit current of 78 μA, delivering an instantaneous power density of 2.54 W/m2 to an external load. In relation to this, a Li-ion battery was charged using the SL-TENG. After a 30-min charging time, the battery achieved a discharge capacity of 0.1 mAh. Through a power management circuit integrated into the SL-TENG, a continuous direct current (DC) of 5 V is outputted, providing sufficient DC power for driving a radio-frequency wireless sensor and other conventional electronics.

Graphical Abstract

Electronic Supplementary Material

Video
12274_2017_1916_MOESM3_ESM.avi
12274_2017_1916_MOESM4_ESM.avi
Download File(s)
12274_2017_1916_MOESM1_ESM.pdf (1.9 MB)

References

【1】
【1】
 
 
Nano Research
Pages 2862-2871

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Du X, Li N, Liu Y, et al. Ultra-robust triboelectric nanogenerator for harvesting rotary mechanical energy. Nano Research, 2018, 11(5): 2862-2871. https://doi.org/10.1007/s12274-017-1916-5

1418

Views

56

Crossref

N/A

Web of Science

56

Scopus

2

CSCD

Received: 26 September 2017
Revised: 30 October 2017
Accepted: 07 November 2017
Published: 12 May 2018
© Tsinghua University Press and Springer-Verlag GmbH Germany, part of Springer Nature 2017