AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (1.4 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article

The Contact Interface Engineering of All-Sulfide-Based Solid State Batteries via Infiltrating Dissoluble Sulfide Electrolyte

Lei Xi, Yu Li, Dechao Zhang, Zhengbo Liu, Xijun Xu, Jun Liu ( )
Guangdong Provincial Key Laboratory of Advanced Energy Storage Materials, School of Materials Science and Engineering, South China University of Technology, Guangzhou 510641, China
Show Author Information

Abstract

All-solid-state lithium batteries (ASSLBs) based on sulfide solid electrolytes (SEs) are one of the most promising strategies for next-generation energy storage systems and electronic devices. However, the poor chemical/electrochemical stability of sulfide SEs with oxide cathode materials and high interfacial impedance, particularly due to physical contact failure, are the major limiting factors to the development of sulfide SEs in ASSLBs. Herein, the composite cathode of MOF-derived Fe7S8@C and Li6PS5Br fabricated by an infiltration method (IN–Fe7S8) with dissoluble sulfide electrolyte (dissoluble SE) is reported. Dissoluble SE can easily infiltrate the porous sheet-type Fe7S8@C cathode to homogeneously contact with Fe7S8 nanoparticles that are embedded in the surrounding carbon matrixes and form a fast ionic transport network. Benefiting from applying dissoluble SE and Fe7S8@C, the IN-Fe7S8-based cells displayed a reversible capacity of 510 mAh g−1 after 180 cycles at 0.045 mA cm−2 at 30 °C. This work demonstrates a novel and practical method for the development of high-performance all-sulfide-based solid state batteries.

Electronic Supplementary Material

Download File(s)
eem-6-6-e12461_ESM.docx (5.9 MB)

References

【1】
【1】
 
 
Energy & Environmental Materials

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Xi L, Li Y, Zhang D, et al. The Contact Interface Engineering of All-Sulfide-Based Solid State Batteries via Infiltrating Dissoluble Sulfide Electrolyte. Energy & Environmental Materials, 2023, 6(6). https://doi.org/10.1002/eem2.12461

703

Views

6

Downloads

15

Crossref

18

Web of Science

15

Scopus

2

CSCD

Received: 10 March 2022
Revised: 10 May 2022
Published: 08 June 2022
© 2022 Zhengzhou University.