Chinese Journal of Aeronautics Open Access Editor-in-Chief: Xiaofeng Sun   
Volume 38 Issue 5, May 2025
Views & Comments
Views & Comments
Is brain-inspired intelligence a new dawn for infrared imaging missile anti-interference strategies?
Published: 07 March 2025
2025, 38(5)
Research Highlight
Research Highlight
Thermoacoustic instability: Challenges, advances, and future directions in combustors
Published: 04 March 2025
2025, 38(5)
Review
Review | Open Access
Review on internal flow mechanism and control methods of axial flow compressor at low Reynolds number
Published: 25 December 2024
2025, 38(5)
Fluid Mechanics and Flight Mechanics
Full Length Article | Open Access
A production term correction for Menter shear-stress transport turbulence model for adverse pressure gradient flows before separation
Published: 16 December 2024
2025, 38(5)
Full Length Article | Open Access
Numerical investigation of annular expansion-deflection nozzle flow under varying backpressure changing rate
Published: 30 August 2024
2025, 38(5)
Full Length Article | Open Access
Novel control method of vortex breakdown over delta wing using dual synthetic jets
Published: 06 December 2024
2025, 38(5)
Full Length Article | Open Access
Evolution of three-dimensional separation flows in stator passages of an aggressive compressor transition duct
Published: 26 December 2024
2025, 38(5)
Full Length Article | Open Access
Evaporation of sub-millimeter flying dinitrogen tetroxide droplet under high temperature and pressure: Experimental measurement and theoretical modeling
Published: 02 January 2025
2025, 38(5)
Full Length Article | Open Access
Influence of injection positions on combustion performance in kerosene-fueled multi-cavity Scramjet combustor
Published: 16 January 2025
2025, 38(5)
Full Length Article | Open Access
Simultaneous transverse and spanwise OH*-chemiluminescence imaging of lean blowoff events in two-dimensional bluff-body stabilized premixed flames
Published: 07 January 2025
2025, 38(5)
Solid Mechanics and Vehicle Conceptual Design
Cover Article | Open Access
Coupled aeroelastic analysis of a panel in supersonic flow with add-on acoustic black hole
Published: 02 January 2025
2025, 38(5)
Full Length Article | Open Access
Multi-objective optimization on thermomechanical behaviors of temperature-dependent graphene platelet reinforced sandwich plates
Published: 20 December 2024
2025, 38(5)
Full Length Article | Open Access
Oscillation and hysteresis characteristics of high-speed duct during TBCC inlet mode transition under mildly throttled condition
Published: 06 November 2024
2025, 38(5)
Full Length Article | Open Access
A systematic evaluation of helicopter cabin noise: Case study of Robinson R44 RAVEN Ⅱ
Published: 24 November 2024
2025, 38(5)
Full Length Article | Open Access
A thrust estimation and control method of an adaptive cycle engine based on improved MFAC algorithm
Published: 27 January 2025
2025, 38(5)
Full Length Article | Open Access
FFD-Clustering: An unsupervised anomaly detection method for aero-engines based on fuzzy fusion of variables and discriminative mapping of features
Published: 16 December 2024
2025, 38(5)
Full Length Article | Open Access
Aerodynamic-driven morphing aircraft and its overall design
Published: 02 December 2024
2025, 38(5)
Full Length Article | Open Access
Global integration design method of acceleration and deceleration control schedule for variable cycle engine
Published: 27 December 2024
2025, 38(5)
Full Length Article | Open Access
Belief reliability modeling and analysis for TPS considering physical principles, degradation mechanism and epistemic uncertainties
Published: 31 December 2024
2025, 38(5)
Full Length Article | Open Access
A semi-implicit partition algorithm for fluid–structure coupling problems based on modal force prediction-correction
Published: 21 January 2025
2025, 38(5)
Full Length Article | Open Access
Nonlinear forced vibration of fluid-conveying layered pipes with weak interface and one end movable
Published: 20 January 2025
2025, 38(5)
Electronics and Electrical Engineering and Control
Full Length Article | Open Access
C-SPPO: A deep reinforcement learning framework for large-scale dynamic logistics UAV routing problem
Published: 07 September 2024
2025, 38(5)
Full Length Article | Open Access
Physics-guided interpretable CNN for SAR target recognition
Published: 24 September 2024
2025, 38(5)
Full Length Article | Open Access
HF skywave communication for air-to-ground networks: A cooperative transmission framework
Published: 15 October 2024
2025, 38(5)
Full Length Article | Open Access
A joint resource allocation strategy in a radar-communication coexistence network for target tracking and user serving
Published: 19 November 2024
2025, 38(5)
Full Length Article | Open Access
Optical signal characteristics analysis of atmospheric disturbance density fields generated by high-speed aircraft
Published: 12 October 2024
2025, 38(5)
Full Length Article | Open Access
Cumulative thermal coupling modeling and analysis of oil-immersed motor-pump assembly for electro–hydrostatic actuator
Published: 24 September 2024
2025, 38(5)
Full Length Article | Open Access
UAV clusters information geometry fusion positioning method with LEO satellite system
Published: 04 October 2024
2025, 38(5)
Full Length Article | Open Access
Robust recursive sigma point Kalman filtering for Huber-based generalized M-estimation
Published: 02 September 2024
2025, 38(5)
Full Length Article | Open Access
A fast-aware multi-target response prediction approach and its application in aeronautical engineering
Published: 06 November 2024
2025, 38(5)
Material Engineering and Mechanical Manufacturing
Full Length Article | Open Access
Surrogate-based buckling analysis and optimization of composite plates modeled using a novel nonlinear function to describe fiber orientation
Published: 04 March 2025
2025, 38(5)
Full Length Article | Open Access
An optimization framework for enhancing profile accuracy in robotic grinding of compressor blade edge
Published: 06 September 2024
2025, 38(5)
Full Length Article | Open Access
Enhancing cathode design by considering complex motion and variations of electric field distribution in counter-rotating electrochemical machining
Published: 12 October 2024
2025, 38(5)