Chinese Journal of Aeronautics Open Access Editor-in-Chief: Xiaofeng Sun   
Volume 37 Issue 6, June 2024
PP. 1-520
|
34 articles
Editorial
Editorial | Open Access
An anti-icing scaling method for wind tunnel tests of aircraft thermal ice protection system
Published: 05 April 2024
2024, 37(6): 1-6
Fluid Mechanics and Flight Mechanics
Full Length Article | Open Access
Body-force modeling considering induced upstream effects for a transonic compressor with total temperature distortion
Published: 14 February 2024
2024, 37(6): 7-19
Full Length Article | Open Access
Effects of mid-passage gap with a variable surface angle on a turbine vane endwall’s aerothermal and film cooling performances
Published: 30 March 2024
2024, 37(6): 20-37
Full Length Article | Open Access
Full lifetime demonstration of a Micro-Cathode-Arc thruster evolution characteristics
Published: 01 April 2024
2024, 37(6): 38-49
Full Length Article | Open Access
Piezoelectric resonant ice protection systems - Part 2/2: Evaluation of benefits at aircraft level
Published: 21 March 2024
2024, 37(6): 50-63
Full Length Article | Open Access
Simulation of an aircraft thermal management system based on vapor cycle response surface model
Published: 08 March 2024
2024, 37(6): 64-77
Full Length Article | Open Access
A deformation criterion of pressurized non-circular cross-section cabin and its effects on cruise performance of BWB civil aircraft
Published: 28 February 2024
2024, 37(6): 78-88
Full Length Article | Open Access
Novel data-driven sparse polynomial chaos and analysis of covariance for aerodynamics of compressor cascades with dependent geometric uncertainties
Published: 04 April 2024
2024, 37(6): 89-108
Full Length Article | Open Access
Investigation of control effects of end-wall self-adaptive jet on three-dimensional corner separation of a highly loaded compressor cascade
Published: 12 April 2024
2024, 37(6): 109-126
Solid Mechanics and Vehicle Conceptual Design
Full Length Article | Open Access
Controlled flight of a self-powered micro blimp driven by insect-sized flapping-wing thrusters
Published: 01 February 2024
2024, 37(6): 127-136
Full Length Article | Open Access
Motion-pressure coupled control and simulation of long-endurance capability for multicapsule stratospheric airships
Published: 21 February 2024
2024, 37(6): 137-150
Full Length Article | Open Access
Data-driven active vibration control for helicopter with trailing-edge flaps using adaptive dynamic programming
Published: 28 February 2024
2024, 37(6): 151-166
Electronics and Electrical Engineering and Control
Full Length Article | Open Access
Ballistic target recognition based on multiple data representations and deep-learning algorithms
Published: 01 February 2024
2024, 37(6): 167-181
Full Length Article | Open Access
Distributed dynamic task allocation for unmanned aerial vehicle swarm systems: A networked evolutionary game-theoretic approach
Published: 26 December 2023
2024, 37(6): 182-204
Full Length Article | Open Access
A novel Bayesian-based INS/GNSS integrated positioning method with both adaptability and robustness in urban environments
Published: 06 December 2023
2024, 37(6): 205-218
Full Length Article | Open Access
Absolute pose estimation of UAV based on large-scale satellite image
Published: 26 December 2023
2024, 37(6): 219-231
Full Length Article | Open Access
Adaptive nonlinear Kalman filters based on credibility theory with noise correlation
Published: 18 April 2024
2024, 37(6): 232-243
Full Length Article | Open Access
Dynamically updated digital twin for prognostics and health management: Application in permanent magnet synchronous motor
Published: 29 December 2023
2024, 37(6): 244-261
Full Length Article | Open Access
Reorientation and obstacle avoidance control of free-floating modular robots using sinusoidal oscillator
Published: 08 March 2024
2024, 37(6): 262-275
Full Length Article | Open Access
Adaptive active inceptor design under shared control architecture for nonlinear pilot-induced oscillations
Published: 21 March 2024
2024, 37(6): 276-292
Full Length Article | Open Access
MADRL-based UAV swarm non-cooperative game under incomplete information
Published: 25 March 2024
2024, 37(6): 293-306
Full Length Article | Open Access
Design of acceleration control schedule for adaptive cycle engine based on direct simulation model
Published: 23 December 2023
2024, 37(6): 307-318
Full Length Article | Open Access
A star identification algorithm for rolling shutter exposure based on Hough transform
Published: 28 December 2023
2024, 37(6): 319-330
Full Length Article | Open Access
A method for active deception jamming discrimination based on frequency response
Published: 29 December 2023
2024, 37(6): 331-347
Material Engineering and Mechanical Manufacturing
Full Length Article | Open Access
Design of an aircraft autonomous traction taxiing system based on hydraulic secondary control
Published: 31 October 2023
2024, 37(6): 348-359
Full Length Article | Open Access
Repair tolerance assessment for aircraft composite structures using Bayesian updating
Published: 30 March 2024
2024, 37(6): 360-391
Full Length Article | Open Access
Temperature field characteristics of CF/PEEK thermoplastic composites formed by automated fiber placement using hot gas torch with slit structure nozzle
Published: 02 April 2024
2024, 37(6): 392-409
Full Length Article | Open Access
Thermal oxidation description methodology of thermal barrier coatings on gas turbine blades considering service characteristics
Published: 28 March 2024
2024, 37(6): 410-424
Full Length Article | Open Access
A flat-foldable equiangular spiral folding pattern inspired by sunflowers for deployable structures
Published: 11 October 2023
2024, 37(6): 425-438
Full Length Article | Open Access
Correcting distortions of thin-walled machined parts by machine hammer peening
Published: 31 October 2023
2024, 37(6): 439-453
Full Length Article | Open Access
TOFD detection of shallow subsurface defects in aluminum alloy thin plates by half-skip mode-converted wave
Published: 03 April 2024
2024, 37(6): 454-463
Full Length Article | Open Access
Early chatter identification based on optimized VMD with multi-band information fusion and compression method in robotic milling process
Published: 16 October 2023
2024, 37(6): 464-484
Full Length Article | Open Access
Forming process chain for manufacturing complex conical-section profiled rings: On a co-design method
Published: 20 December 2023
2024, 37(6): 485-503
Full Length Article | Open Access
Effect of linear friction welding process on microstructure evolution, mechanical properties and corrosion behavior of GH4169 superalloy
Published: 29 March 2024
2024, 37(6): 504-520