@article{MADARIAGA2025, 
author = {Aitor MADARIAGA and Gorka ORTIZ-DE-ZARATE and Pedro José ARRAZOLA},
title = {Improved surface integrity in Inconel 718 using small diameter hammer peening tools},
year = {2025},
journal = {Chinese Journal of Aeronautics},
volume = {38},
number = {7},
keywords = {In-situ tests, Machine hammer peening, Nickel-based alloy, Residual stresses, Surface integrity, X-ray diffraction},
url = {https://www.sciopen.com/article/10.1016/j.cja.2025.103554},
doi = {10.1016/j.cja.2025.103554},
abstract = {Machine Hammer Peening (MHP) is an emergent treatment that induces high compressive Residual Stresses (RS) which can enhance the in-service performance of components. This paper studies the use of small diameter MHP tools to improve the Surface Integrity (SI) of the nickel-based alloy Inconel 718 used in critical aero-engine components. Complementarily, the relaxation of RS is analyzed by in-situ annealing tests at in-service temperature combined with X-ray diffraction measurement. For this purpose, age hardened Inconel 718 discs were turned as reference condition, and then a pneumatic MHP tool was used under different conditions: two tool diameters (4 mm and 12 mm), feed rates (2.5 m/min and 5.0 m/min) and stepover distances (0.07 mm and 0.35 mm). Subsequently, surface topography characterization, RS measurements, nanoindentation tests, and microstructural observations were conducted. The in-situ annealing tests were done in the X-ray diffractometer at 550 °C for exposure periods from 0 to 20 h. The results demonstrate that 4 mm diameter tools generate smooth surfaces and induce significant compressive RS within a 0.5 mm thick layer. Residual stresses are relaxed, but they remain compressive even after a long thermal exposure. The microstructure of the surface layer (&lt;10–15 μm) was affected by the preceding turning operation, but importantly, MHP did not induce additional damage.}
}