AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Open Access

Mixing and initiating mechanism of internal injection oblique detonation engine

Jingyu ZHANGa, Guoqiang HEa( ), Yunfeng LIUb,c, Fei QINa, Xianggeng WEIa, Shaohua ZHUa
National Key Laboratory of Solid Rocket Propulsion, Northwestern Polytechnical University, Xi’an 710072, China
Institute of Mechanics, Chinese Academy of Sciences, Beijing 100190, China
School of Engineering Science, University of Chinese Academy of Sciences, Beijing 100049, China

Peer review under responsibility of Editorial Committee of CJA

Show Author Information

Abstract

This paper presents the results of free-jet experiments conducted on an internal injection oblique detonation engine in a large-scale hypersonic shock tunnel. To overcome the challenges of non-uniform mixing and the failure of oblique detonation wave initiation when using liquid fuel, a combined strut-wall injection configuration was employed. Initiation was achieved by introducing a bump structure on the wedge. The results demonstrate that this strategy for mixing and initiation effectively establishes the oblique detonation wave combustion flow field. To further investigate the fuel mixing and initiation processes in the oblique detonation engine, three-dimensional numerical simulations consistent with the experimental conditions were carried out using the Reynolds-Averaged Navier-Stokes (RANS) method. The simulation results reveal that the high-speed gas flow generates shock waves as it passes through the central strut and transverse fuel jets. These shock waves are reflected by the wall, forming a series of shocks in the mixing section. The kerosene injected from the strut injectors does not react during the mixing phase. However, due to the influence of the high-temperature boundary layer, the kerosene injected through the wall undergoes pre-combustion. The separation zone upstream of the bump generates separation shock waves, allowing the multi-wave point to stabilize at a short distance from the leading edge of the wedge.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
ZHANG J, HE G, LIU Y, et al. Mixing and initiating mechanism of internal injection oblique detonation engine. Chinese Journal of Aeronautics, 2026, 39(2). https://doi.org/10.1016/j.cja.2025.103614

831

Views

7

Crossref

4

Web of Science

5

Scopus

0

CSCD

Received: 09 December 2024
Revised: 03 January 2025
Accepted: 04 March 2025
Published: 06 June 2025
© 2025 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).