AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Development of a new high-shear and low-pressure grinding wheel and its grinding characteristics for Inconel718 alloy

Bing LIUa, Yebing TIANa,b( ), Jinguo HANa, Linguang LIa, Zhiqiang GUa, Xintao HUa
School of Mechanical Engineering, Shandong University of Technology, Zibo 255049, China
Institute for Advanced Manufacturing, Shandong University of Technology, Zibo 255049, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

Nickel-based alloy has been widely used due to its outstanding mechanical properties. However, Nickel-based alloy is a typical difficult-to-machine material, which is a great constrain for its application in the manufacturing field. To improve the surface quality of the ground workpiece, a new high-shear and low-pressure grinding wheel, with high ratio of tangential grinding force to normal grinding force, was fabricated for the grinding of selective laser melting (SLM) manufactured Inconel718 alloy. The principle of high-shear and low-pressure grinding process was introduced in detail, which was quite different from the conventional grinding process. The fabrication process of the new grinding wheel was illustrated. A serial of experiments with different processing parameters were carried out to investigate the grinding performance of the developed grinding wheel via analyzing surface roughness and surface morphology of the ground workpiece. The optimal processing parameters of high-shear and low-pressure grinding were obtained. The surface roughness of ground workpiece was reduced to 0.232 μm from the initial value of 0.490 μm under the optimal grinding conditions. It was found that the initial scratches on the ground workpiece were almost completely removed after the observations with the metalloscopy and the field-emission scanning electron microscopy (FE-SEM). The capability of the newly developed high-shear and low-pressure grinding wheel was validated.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 278-286

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
LIU B, TIAN Y, HAN J, et al. Development of a new high-shear and low-pressure grinding wheel and its grinding characteristics for Inconel718 alloy. Chinese Journal of Aeronautics, 2022, 35(12): 278-286. https://doi.org/10.1016/j.cja.2021.08.013

639

Views

31

Crossref

29

Web of Science

29

Scopus

1

CSCD

Received: 03 June 2021
Revised: 27 June 2021
Accepted: 25 July 2021
Published: 16 September 2021
© 2021 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).